User's Manual Part 1

48 OEMV Family Installation and Operation User Manual Rev 5B
Chapter 3 Installation and Set Up
Table 11: FlexPak Status Indicators
3.3.5 DL-V3 Status Indicators
The LEDs on the front of the DL-V3 represent these categories:
• Power
• Receiver Status
• COMs (COM1, COM2 and AUX)
• COM3
• Satellite Tracking
• Flash Card Memory
• Positioning Mode
• Occupation Time
Power
The power indicator glows orange when the receiver is powered and then glows green once the
receiver has been turned on. See also the DL-V3 Power Down and the Power Button section on
Page 40.
Status
The status indicator flashes orange when the receiver is first turned on. Under normal operation,
this LED is off. If a status event occurs, the LED flashes orange again. See also Chapter 7,
Built-In Status Tests starting on Page 118 and the RXSTATUS log.
Communication Ports (excluding COM3)
The top of the COM1, COM2 and AUX LEDs flash GREEN when transmitting data while the
bottom of them flash AMBER when receiving data.
Indicator FlexPak-V1/FlexPak-V1G FlexPak-V2
Antenna/
Position Valid
Solid GREEN with valid position /
No error mode
Solid GREEN with valid position /
Solid RED indicates a board error
COM1 Flashing GREEN when transmitting
data from COM1 /
Flashing RED when receiving data
on COM1
Flashing GREEN when
transmitting data from COM1 /
Flashing RED when receiving data
on COM1
COM2 Flashing GREEN when transmitting
data from COM1 /
Flashing RED when receiving data
on COM1
Flashing GREEN when
transmitting data from COM1 /
Flashing RED when receiving data
on COM1
Power Solid RED when +12V applied Solid RED when +12V applied