User's Manual Part 1

Installation and Set Up Chapter 3

OEMV Family Installation and Operation User Manual Rev 5B 49

COM3

The COM3 section of the LED panel on the front of the DL-V3, has two LEDs:

• 1 for Bluetooth Mode (default)

• 1 for Ethernet Mode

Only one mode may be used at a time on COM3. The active mode’s LED glows (blue for Bluetooth

and orange for Ethernet). See also Appendix C, Ethernet Configuration starting on Page 189.

Satellite Tracking

The LED that is glowing, and its color, corresponds to the number of GPS-only, or GLONASS

and GPS-combined, satellites being tracked by the DL-V3, where the first LED to the left is #1,

see Table 12:

Table 12: Satellite Tracking LEDs

Flash Card Memory

The number of LEDs that are glowing, and their colors, correspond to the amount of memory

left in the DL-V3’s compact flash card, where the first LED to the left is #1, see Table 13.

 If all 5 flash card LEDs are flashing, it can mean that there is no compact flash card in the DL-

V3, or that the card in the unit is not formatted (see Section 3.3.8, DL-V3 Removable Compact

Flash Memory Card starting on Page 52).

Table 13: Flash Card Memory LEDs

LED#

# of

SVs

LED

Color

≤ 3

Red

2 4 or 5 Amber

3 6 or 7 Green

4 8 or 9 Green

≥ 10

Green

# of LEDs Capacity LED Color

1 Capacity ≤ 20%

Red

a. This red LED can also mean that the card was not formatted, and

placed in the receiver, when the receiver was powered off.

40% ≥ Capacity > 20%

Amber

60% ≥ Capacity > 40%

Green

80% ≥ Capacity > 60%

Green

Capacity > 80%

Green