User's Manual Part 2

Technical Specifications Appendix A
OEMV Family Installation and Operation User Manual Rev 5B 183
A.9.2 Optional Cables
Each SMART-V1 comes with its own multi-cable in either a USB (NovAtel part number 01017893)
or CAN format (NovAtel part number 01017894). These cables are also available with no connectors
at the USB or CAN end (NovAtel part numbers 01017923 and 01017922 respectively) but with tin-
terminated ends. All 4 cables have an 18-pin Switchcraft connector at one end and are 3 m in length.
Section A.9.2.1 below contains pin-out information for a SMART-V1 USB multi-cable while Section
A.9.2.2 on Page 184 contains pin-out information for a SMART-V1 CAN multi-cable. Figures 69 and
70 on Page 185 show examples of the cables with their DB-9 and/or USB ends.
 Switchcraft cable connector pin numbers are labelled on the connectors.
A.9.2.1 18-Pin Switchcraft to USB Multi-Cable (NovAtel part number 01017893)
Table 41: USB Multi-Cable Connector Pin-Outs
2.5 m
0.5 m
J3
J2
J4
PWR
PWR2
TIMEMARK
Reser
v
ed
DIG GND
GND2
GND
J1 Switchcraft J2 DB-9 socket J3 DB-9 socket J4 USB A
Pin Signal Pin Signal Pin Signal Pin Signal
1 PWR 1 N/A 1 N/A 1 N/A
2 GND 2 TX1 (+) 2 TX2 2 USB D (-)
3 TX2 3 RX1 (+) 3 RX2 3 USB D (+)
4 RX2 4 N/A 4 N/A 4 Digital GND
5 TX1 (+) 5 Digital GND 5 Digital GND
6 RX1 (+) 6 N/A 6 N/A
7 TX1 (-) 7 N/A 7 N/A
8 RX1 (-) 8 N/A 8 N/A
9 Reserved 9 N/A 9 N/A
10 USB D (-)
 See also Table 43 on Page 184 for the optional USB cable’s
bare tagged wire colors.
WARNING!: It is important that you read the SMART-V1
Power Warning on Page 11 of the Notice section.
11 Digital GND
12 TIMEMARK
13 TX3 (+)
14 RX3 (+)
15 TX3 (-)
16 USB D (+)
17 PWR2
18 GND2