User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
16 SMART-MR10 User Manual Rev 0B
Foreword
Foreword
Congratulations!
Congratulations on your purchase of the SMART-MR10, a smart antenna capable of receiving GPS
L1+L2, GLONASS L1+L2, and L-band signals, with exceptional flexibility and performance.
NovAtel is an industry leader in state-of-the-art Global Navigation Satellite Systems (GNSS) receiver
design. We believe that our SMART-MR10 will meet your high expectations, and are working hard to
ensure that future products and enhancements maintain that level of satisfaction.
This is your primary hardware and software reference.
Scope
This manual provides sufficient detail on the SMART-MR10, to allow you to effectively integrate and
fully operate it. The information in this manual is a companion to the OEMV family information in
the OEMV Firmware Reference Manual and the OEMV Installation and Operation User Manual.
After the addition of accessories and a power supply, the SMART-MR10 is ready to go.
SMART-MR10 utilizes a comprehensive user-interface command structure, which requires
communications through its communications (COM) ports. This manual describes the SMART-
MR10-specific commands and logs, seeCommands starting on Page 73 and Logs starting on Page 91.
Other supplementary manuals, available on the accompanying CD and on our Web site at
http://www.novatel.com/support/docupdates.htm
, aid you in using the other commands and logs
available in the OEMV family of receivers.
PC Utilities are also described, see Chapter 4 starting on Page 44. Integrated with the Control and
Display Unit (CDU) software, these utilities provide graphical user interfaces for logging to a PC/
laptop, upgrading, and converting data types.
Prerequisites
The installation chapters of this document provide information concerning installation requirements
and considerations for SMART-MR10. To run the PC software supplied, your personal computer must
meet or exceed this minimum configuration:
• Windows-compatible mouse or pointing device and SVGA display
Although previous experience with Windows is not necessary to use CDU, familiarity with certain
actions that are customary in Windows will assist in the use of the program. This manual has been
written with the expectation that you already have a basic familiarity with Windows.
Conventions
The following conventions are used in this manual:
This is a notebox that contains important information.