User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
Introduction Chapter 1
SMART-MR10 User Manual Rev 0B 19
switched to RS422.
• Rugged, water and dust tight enclosure, consisting of a cast aluminum base and plastic radome.
• Bluetooth
• Three (3) daylight viewable status LED indicators.
• Range of installation options, including a quick-release mounting plate and a 5m power/data
cable with tinned/tagged wires.