User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
21 SMART-MR10 User Manual Rev 0B
Chapter 2 Installation and Setup
This chapter contains instructions and tips for setting up your SMART-MR10.
2.1 Additional Equipment Required
For the receiver to perform optimally, the following additional equipment is required:
• A PC/laptop (user-supplied)
• A means of communicating with, and powering, the SMART-MR10
• SMART-MR10 cable (see Appendix D Replacement Parts on page 98 for part
numbers). Refer to Figure 3, Simplified SMART-MR10 Setup on Page 23 for COM
and power connections
Use a serial COM connection to communicate with the receiver first.
• A fused power supply (user-supplied) or other user equipment
2.1.1 SMART-MR10 Setup
To connect and power your SMART-MR10:
1. Mount the SMART-MR10 on a secure, stable part of the vehicle (for example, cab roof) with an
unobstructed view of the sky from horizon to horizon, see Section 2.1.5, Mounting the SMART-
MR10 on Page 28.
2. Establish a physical communication connection between the SMART-MR10 and the PC/laptop.
Connect the COM and Power port on the back of the SMART-MR10, see Figure 2 below, to a
DB-9 serial port on a PC, laptop or other data storage device.
Figure 2: SMART-MR10 Connector