User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
24 SMART-MR10 User Manual Rev 0B
Chapter 2 Installation and Setup
3. Select Install the OEMV GPS PC Utilities from the window that is automatically displayed.
If the window does not automatically open when the CD is inserted, select Run from the Start
menu and select the Browse button to locate Setup.exe on the CD drive.
4. Install the PC Utilities by advancing through the steps provided in the NovAtel PC Utilities setup
program.
2.1.3 Power Supply Requirements
The SMART-MR10 requires +8 to +36 VDC for the input power to the receiver. See Page 65 for more
power supply specifications.
The SMART-MR10 cable provides power in (with a BATT+ label) and power ground (with a BATT-
label) bare wires for connections from the SMART-MR10 to a 12 to 24V vehicular power system (or
equivalent) protected by a user-supplied fuse. NovAtel recommends an automotive blade-type fuse,
rated for 5A with an operating voltage of more than 36V. For cable details, refer to Appendix A.2.3,
SMART-MR10 Connector and Cable Requirements starting on page 72.
WARNING!: The SMART-MR10 power source must be protected by a 5A fuse or damage to
wiring may result (not covered by warranty). If the voltage supplied is above or
below the specified range, the receiver will suspend operation. If the voltage
supplied is above 48V, the receiver may be permanently damaged, voiding your
warranty.