User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
28 SMART-MR10 User Manual Rev 0B
Chapter 2 Installation and Setup
2.1.5 Mounting the SMART-MR10
When installing the SMART-MR10:
• Choose a location that has a clear view of the sky so that each satellite above the
horizon can be tracked without obstruction.
• Mount on a secure, stable structure capable of safe operation in the specific
environment. Typical installation is the vehicle roof.
2.1.6 Connecting Data Communications Equipment
To communicate with the receiver by sending commands and obtaining logs, a connection to data
communications equipment is required. See Table 7 on page 69 for more information.
2.2 Additional Features and Information
This section contains information on additional features of the SMART-MR10, which may affect the
overall design of your receiver system.
2.2.1 MKI and PPS Strobes
Input (MKI) and output (PPS) strobes provide status and synchronization signals. PPS is a 3.3V
CMOS output; MKI is a 5V-tolerant input. Pin-out information can be found on Page 69.
MKI can be used in conjunction with the MARKTIME and MARKPOS logs. For information about
these logs, refer to OEMV Family Firmware Reference Manual, available on the NovAtel Support
Web site at http://www.novatel.com/support/docupdates.htm
.
2.2.2 Status Indicators
LED indicators on the SMART-MR10 provide receiver status information:
• Position Status
• Position Type
• Power