User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
Installation and Setup Chapter 2
SMART-MR10 User Manual Rev 0B 31
The CAN module is generally not user-interactive. It is activated when a SETCANNAME command
is entered, and after a SAVECONFIG, the CAN module is activated immediately on all subsequent
start-ups. The module supports the following NMEA2000 Parameter Group Messages (PGN):
• PGN 129029 GNSSPositionData
• PGN 129025 GNSSPositionRapidUpdate
• PGN 129026 COGandSOGRapidUpdate
Table 5: Available CAN Signals on the SMART-MR10
CAN Pins
CAN1+ Pin 3
CAN1- Pin 4