User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
Operation Chapter 3
SMART-MR10 User Manual Rev 0B 37
3.3.1 Base Station Configuration
At the base station, enter the following commands:
interfacemode port rx_type tx_type [responses]
fix position latitude longitude height
log port message [trigger [period]]
Examples of these commands include the following:
RTCA interfacemode com2 none rtca off
fix position 51.11358042 -114.04358013 1059.4105 (enter your own lat, lon, hgt)
log com2 rtcaobs ontime 1
log com2 rtcaref ontime 10
log com2 rtca1 ontime 5 (optional, enable code-dgps coverage)
log com2 rtcaephem ontime 10 1 (optional)
RTCAOBS2 interfacemode com2 none rtca off
(recommended) fix position 51.11358042 -114.04358013 1059.4105 (enter your own lat, lon, hgt)
log com2 rtcaobs2 ontime 1
log com2 rtcaref ontime 10
RTCM V2.3 interfacemode com2 none rtcm off
fix position 51.11358042 -114.04358013 1059.4105 (enter your own lat, lon, hgt)
log com2 rtcm3 ontime 10
log com2 rtcm22 ontime 10 1
log com2 rtcm1819 ontime 1
log com2 rtcm1 ontime 5 (optional)
RTCM V3 interfacemode com2 none rtcmv3 off
fix position 51.11358042 -114.04358013 1059.4105 (enter your own lat, lon, hgt)
log com2 rtcm1002 ontime 1 (for L1 only models or cards OEMV1 and OEMV1G)
log com2 rtcm1004 ontime 1
(for L1/L2 models or cards OEMV1DF, OEMV2G, and OEMV3G)
log com2 rtcm1006 ontime 10
log com2 rtcm1019 ontime 120
RTCM V3 with GLONASS interfacemode com2 none rtcmv3 off
(recommended) fix position 51.11358042 -114.04358013 1059.4105 (enter your own lat, lon, hgt)
log com2 rtcm1002 ontime 1 (for L1 only models or cards OEMV1 and OEMV1G)
log com2 rtcm1004 ontime 1
(for L1/L2 models or cards OEMV1DF, OEMV2G, and OEMV3G)
log com2 rtcm1010 ontime 1 (for L1 only models or cards OEMV1 and OEMV1G)
log com2 rtcm1012 ontime 1