User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
4 SMART-MR10 User Manual Rev 0B
Table of Contents
4.3 Convert................................................................................................................. 50
4.3.1 RINEX Format............................................................................................. 50
4.3.2 Convert4 Command Line Switches............................................................. 52
4.4 Firmware Upgrades.............................................................................................. 53
4.4.1 Upgrading Using the AUTH Command....................................................... 53
4.4.2 Updating Using the WinLoad Utility ............................................................ 54
5 Bluetooth® Configuration 59
5.1 Enable Bluetooth on the SMART-MR10 Receiver................................................ 59
5.2 Set Up a PC/Laptop with a Bluetooth Adaptor ..................................................... 60
5.3 Locate a Bluetooth-Enabled SMART-MR10 in Range ......................................... 60
5.4 Communicate with the SMART-MR10 Using Bluetooth ....................................... 61
5.5 Stop Communicating with SMART-MR10 Using Bluetooth.................................. 63
A Technical Specifications 64
SMART-MR10 Receiver Performance ...................................................................... 64
SMART-MR10 Specifications .................................................................................... 65
B Commands 73
Syntax Conventions .................................................................................................. 73
BTCONTROL Enable/Disable Bluetooth ................................................................... 74
COM Configure COM Port ........................................................................................ 75
FRESET Clear Selected Data from NVM and Reset ................................................. 78
LOG Request Logs from the Receiver ...................................................................... 79
PDPFILTER Enable, disable or reset the PDP filter .................................................. 84
PDPMODE Select the PDP mode and dynamics ...................................................... 85
RADARCFG Configure the ER output ....................................................................... 86
RESET Performs a hardware reset ........................................................................... 88
SBASCONTROL Set SBAS test mode and PRN ...................................................... 89
C Logs 91
Position Logs ............................................................................................................. 91
Other Logs ................................................................................................................. 93
D Replacement Parts 98
SMART-MR10 ........................................................................................................... 98
Accessories ............................................................................................................... 98