User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
SMART-MR10 User Manual Rev 0B 5
Tables
1 SMART-MR10 Controller Models............................................................................... 20
2 SMART-MR10 Connector Pin-Out............................................................................. 22
3 Use of MODE Pin....................................................................................................... 22
4 SMART-MR10 LED Status Indicators........................................................................ 29
5 Available CAN Signals on the SMART-MR10............................................................ 31
6 NovAtel Logs for RINEX Conversion ......................................................................... 51
7 SMART-MR10 Evaluation Cable Pinouts................................................................... 69
8 SMART-MR10 Streamlined Cable Pinouts ................................................................ 71
9 SMART-MR10 Mating Connectors............................................................................. 72
10 Recommended Fuses................................................................................................ 72
11 Commonly Used SMART-MR10 Commands in Alphabetical Order .......................... 73
12 COM Serial Port Identifiers ........................................................................................ 76
13 Parity.......................................................................................................................... 76
14 Handshaking .............................................................................................................. 76
15 FRESET Target.......................................................................................................... 78
16 Detailed Serial Port Identifiers.................................................................................... 82
17 Response Modes ....................................................................................................... 87
18 SMART-MR10 Logs in Alphabetical Order ................................................................ 93
19 Position or Velocity Type............................................................................................ 95
20 Solution Status........................................................................................................... 96
21 Component Type........................................................................................................ 97