User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
56 SMART-MR10 User Manual Rev 0B
Chapter 4 PC Utilities
Open a File to Download
From the file menu choose Open. Use the Open dialog to browse for your file, see Figure 12,
WinLoad’s Open Dialog on page 56.
Figure 12: WinLoad’s Open Dialog
Once you have selected your file, the name should appear in the main display area and in the title bar,
see Figure 13 below.
Figure 13: Open File in WinLoad
Communications Settings
To set the communications port and baud rate, select COM Settings from the Settings menu. Choose
the port on your PC from the Com Port dropdown list and the baud rate from the Download Baudrate
dropdown list. The baud rate should be as high as possible (the default of 115200 is preferred).