User's Manual

SMART-MR10 User Manual Rev 0B 59
Chapter 5 Bluetooth® Configuration
Bluetooth is a wireless radio communication standard designed for use over short ranges (within
10 m). This chapter describes how to:
• Enable Bluetooth on the SMART-MR10 receiver
• Set up a PC/laptop with a Bluetooth adaptor
• Locate a Bluetooth-enabled SMART-MR10 in range
• Communicate with the SMART-MR10 using Bluetooth
• Stop communicating with the SMART-MR10 using Bluetooth
5.1 Enable Bluetooth on the SMART-MR10 Receiver
The SMART-MR10 Bluetooth configuration is illustrated in Figure 18:
Figure 18: SMART-MR10 Bluetooth Configuration
Bluetooth is configured on the SMART-MR10 COM3 port and, by default, is enabled.
 If the SMART-MR10 is turned off (or power is removed) then turned back on, the Bluetooth
mode is returned to the state it was in before power-down, as long as the SAVECONFIG
command was issued before the unit was powered off. When you issue a FRESET command,
COM3 defaults to Bluetooth mode.
If Bluetooth has been disabled, you will need to enable it before you can use it. From a PC/laptop,
connect to a SMART-MR10 serial port. Open communication with the receiver using HyperTerminal
or CDU. Refer to Appendix B.2, BTCONTROL Enable/Disable Bluetooth starting on page 74 for
further information. Once your PC/laptop is configured for Bluetooth operation, you will be able to
communicate with the SMART-MR10 through Bluetooth.
SMART-MR10
CPU
Bluetooth
Module
DB9 Labeled COM1
DB9 Labeled COM2
COM1
COM2
AUX
COM3
DB9 Labeled AUX
SMART-MR10 Enclosure