User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
Bluetooth® Configuration Chapter 5
SMART-MR10 User Manual Rev 0B 61
Figure 22: My Bluetooth Places Window
5.4 Communicate with the SMART-MR10 Using Bluetooth
1. Double-click the SMART-MR10 device icon in the Entire Bluetooth Neighborhood window, as
shown in Figure 22. The PC/laptop searches for available services. If Bluetooth is working
properly, a COM port service appears.
2. Double-click the COM3 icon. To use the serial COM port, the SMART-MR10 must be “paired”
with the PC/laptop to use the COM3 port. The Bluetooth PIN Code Request dialog appears.
3. Enter the SMART-MR10 default pin number of four zeroes (0000), as shown in Figure 23:
Figure 23: Bluetooth PIN Code Request