User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
62 SMART-MR10 User Manual Rev 0B
Chapter 5 Bluetooth® Configuration
If the code is correct, a new COM dialog opens, showing the PC/laptop COM port that has been
assigned to the Bluetooth link. For example, in Figure 24, the PC/laptop port is COM21.
Figure 24: PC/Laptop COM3 Port Assignment
4. Open a terminal program (HyperTerminal, for example) and configure it to the serial port
specified in the Bluetooth configuration utility. In the above example, the terminal program must
be configured to connect through COM21.
5. Configure the port settings as follows:
9600 bps, no parity, 8 data bits, 1 stop bit, no handshaking, echo off
6. Through the terminal program, connect to the Bluetooth serial port, and verify the connection.
7. Type the following VERSION log request into the command prompt to ensure that the connection
works:
LOG VERSION
The Bluetooth icon in the task bar turns green when it is connected, as shown in Figure 25.
Figure 25: Bluetooth Connected: Green