User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
Bluetooth® Configuration Chapter 5
SMART-MR10 User Manual Rev 0B 63
5.5 Stop Communicating with SMART-MR10 Using Bluetooth
1. Double-click the Bluetooth icon in the task bar, as shown in Figure 20 on page 60, or select
Programs | My Bluetooth Places from the Start menu in Windows. The My Bluetooth Places
window opens.
2. Click the Search for devices in range option from the Bluetooth Tasks side bar on the left of the
My Bluetooth Places window. Bluetooth-enabled devices within range appear in the Entire
Bluetooth Neighborhood folder, as shown in Figure 22 on page 61.
3. Double-click the SMART-MR10 device icon in the Entire Bluetooth Neighborhood window. The
PC/laptop searches for available services. If Bluetooth is working properly, COM port service
appears.
4. Right-click the COM3 icon then select the Disconnect Serial COM Port option. A COM3 dialog
box appears, as shown in Figure 26, requesting confirmation that you want to disconnect.
Figure 26: COM3 Disconnect?
5. Click Yes in the COM3 dialog. The SMART-MR10 Bluetooth is unpaired from your PC/laptop.
When the SMART-MR10 and PC/laptop Bluetooth are unpaired, the Bluetooth icon in the task
bar appears white, as shown in Figure 20 on page 60.