User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
Technical Specifications Appendix A
SMART-MR10 User Manual Rev 0B 69
Table 7: SMART-MR10 Evaluation Cable Pinouts
TYCO
23-PIN
COM1
D-SUB
COM2
D-SUB
COM3
D-SUB
TINNED
LEAD
SIGNAL
NAME
1 PWR+ PWR+
2 PWR- PWR-
3 CAN- CAN-
4 CAN+ CAN+
5 2 TXD2
6 3 RXD2
7 2 TXD1
8 2 RTS1/AUXTX/TXD3
9 SIGGND2 SIGGND2
10 RESERVED
11 RESERVED
12 RESERVED
13 RESERVED
14
CHASSIS GROUND
a
a. Pin 14 is connected to cable shields.
15 5 5 5 SIGGND1 SIGGND1
16 MKI MKI
17 PPS PPS
18 ER ER
19 MODE MODE
20 RESERVED
21 RESERVED
22 3 CTS1/AUXRX/RXD3
23 3 RXD1