User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
SMART-MR10 User Manual Rev 0B 73
Appendix B Commands
The SMART-MR10 firmware implements the OEMV family command set, documented in OEMV
Family Firmware Reference Manual. For convenience, commonly used SMART-MR10 commands
are summarized in Table 11 and documented in this appendix.
Table 11: Commonly Used SMART-MR10 Commands in Alphabetical Order
The arguments for each of these commands are described in the following sections.
For a complete listing and description of the other commands that the SMART-MR10, an OEMV-3
based receiver, is capable of processing, refer to the OEMV Family Firmware Reference Manual.
B.1 SYNTAX CONVENTIONS
The following rules apply when entering commands, at the command prompt, from a keyboard.
1. Courier font is used to illustrate program output or user input.
2. References to other commands, logs or any of their fields are shown in italics.
3. The commands are not case sensitive. For example, you could type either RESET or reset.
4. Except where noted, either a space or a comma can separate commands and their required entries.
For example, you could type either fix position 51.11358042 -114.04358013
1059.4105 or fix position 51.11358042, -114.04358013, 1059.4105.
5. At the end of a command, a carriage return is required. For example, press <Enter> or <Return>
on your keyboard.
6. Responses are provided to indicate whether or not an entered command was accepted. The format
of the response depends on the format of the command. Refer to the OEMV Family Firmware
Reference Manual for more information.
ASCII Command Message ID Description
btcontrol 8205 Enable/disable Bluetooth.
com 4 Configure the receiver’s asynchronous serial ports
communications drivers.
freset 20 Clear data stored in non-volatile memory and reset.
log 1 Request logs from the receiver.
pdpfilter 424 Enable, disable or reset the PDP (Pseudorange Delta-
Phase) filter.
pdpmode 970 Select the PDP filter mode and dynamics.
radarcfg 8192 Configure the ER signal output.
reset 18 Perform a hardware reset.
sbascontrol 652 Set SBAS test mode and PRN.