User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
76 SMART-MR10 User Manual Rev 0B
Appendix B Commands
WARNING!: Use the COM command before using the INTERFACEMODE command on
each port. Turn break detection off using the COM command to stop the port
from resetting because it is interpreting incoming bits as a break command.
Table 12: COM Serial Port Identifiers
Table 13: Parity
Table 14: Handshaking
Binary
a
a. This table lists the commonly used SMART-MR10 COM
ports. For a complete list of COM ports, refer to the
COM Serial Port Identifiers table in the COM command
section of the OEMV Family Firmware Reference
Manual.
ASCII Description
1 COM1 COM port 1
2 COM2 COM port 2
3 COM3 COM port 3 (available over
Bluetooth)
6 THISPORT Current COM port
16 AUX AUX port
Binary ASCII Description
0 N No parity (default)
1 E Even parity
2 O Odd parity
Binary ASCII Description
0 N No handshaking (default)
1 XON XON/XOFF software handshaking
2 CTS CTS/RTS hardware handshaking