User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
Commands Appendix B
SMART-MR10 User Manual Rev 0B 77
Field
Field
Type
ASCII
Value
Binary
Value
Description
Binary
Format
Binary
Bytes
Binary
Offset
1 COM header - - This field contains the
command name or the
message header depending on
whether the command is
abbreviated ASCII, ASCII or
binary, respectively.
- H 0
2 port See Table 12,
COM Serial Port
Identifiers on Page
76
Port to configure.
(default = THISPORT)
Enum 4 H
3 bps/baud 300, 600, 900,
1200, 2400, 4800,
9600, 19200,
38400, 57600,
115200, or 230400
Communication baud rate
(bps).
Bauds of 460800 and 921600
are also available on COM1 of
OEMV-2-based products.
ULong 4 H+4
4 parity See Table 13 on
Page 76
Parity Enum 4 H+8
5 databits 7 or 8 Number of data bits
(default = 8)
ULong 4 H+12
6 stopbits 1 or 2 Number of stop bits
(default = 1)
ULong 4 H+16
7 handshake See Table 14 on
Page 76
Handshaking Enum 4 H+20
8 echo OFF 0 No echo
(default)
Enum 4 H+24
ON 1 Transmit any input characters
as they are received
9 break OFF 0 Disable break detection Enum 4 H+28
ON 1 Enable break detection
(default)