User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
Logs Appendix C
SMART-MR10 User Manual Rev 0B 95
Table 19: Position or Velocity Type
Type (binary) Type (ASCII) Description
0NONE No solution
1 FIXEDPOS Position has been fixed by the FIX POSITION command
2 FIXEDHEIGHT Position has been fixed by the FIX HEIGHT/AUTO
command
8 DOPPLER_VELOCITY Velocity computed using instantaneous Doppler
16 SINGLE Single point position
17 PSRDIFF Pseudorange differential solution
18 WAAS Solution calculated using corrections from an SBAS
19 PROPAGATED Propagated by a Kalman filter without new observations
32 L1_FLOAT Floating L1 ambiguity solution
33 IONOFREE_FLOAT Floating ionospheric-free ambiguity solution
34 NARROW_FLOAT Floating narrow-lane ambiguity solution
48 L1_INT Integer L1 ambiguity solution
49 WIDE_INT Integer wide-lane ambiguity solution
50 NARROW_INT Integer narrow-lane ambiguity solution