User's Manual
Table Of Contents
- Introduction
- Installation and Setup
- Operation
- PC Utilities
- Bluetooth® Configuration
- Technical Specifications
- Commands
- B.1 Syntax Conventions
- B.2 BTCONTROL Enable/Disable Bluetooth
- B.3 COM Configure COM Port
- B.4 FRESET Clear Selected Data from NVM and Reset
- B.5 LOG Request Logs from the Receiver
- B.6 PDPFILTER Enable, disable or reset the PDP filter
- B.7 PDPMODE Select the PDP mode and dynamics
- B.8 RADARCFG Configure the ER output
- B.9 RESET Performs a hardware reset
- B.10 SBASCONTROL Set SBAS test mode and PRN
- Logs
- Replacement Parts
Logs Appendix C
SMART-MR10 User Manual Rev 0B 97
C.2.2 VERSION HW & SW Versions and Serial Numbers
The Component Type of the VERSION log, refer to the OEMV Family Firmware Reference Manual,
is extended to include SMART-MR10 information as in Table .
Table 21: Component Type
For the SMART-MR10, the BT MAC address field has been added, in hexadecimal format, to the
USERINFO block, “
002166000001” in the following example.
[COM1]<VERSION COM1 0 94.5 UNKNOWN 0 156.357 004c0001 3681 5010
< 3
< GPSCARD "N1GA" "DHC09401037" "MCAGTP-1.00-22B"
"3.710" "3.002" "2009/Nov/30" "11:08:19"
< DB_USERAPPAUTO "SmartAg" "0" "" "1.100" ""
"2009/Nov/27" "13:22:29"
< USERINFO "LMX9830" "0212" "002166000001" "" "" "" ""
[COM1]
In the above example, the firmware is shown as 3.710 and the SMART-MR10 application is shown as
1.100.
Binary Value
a
a. Unused numbers are reserved for future use.
ASCII Value Description
0 UNKNOWN Unknown Component
1 GPSCARD OEMV GPSCard Component
3 ENCLOSURE SMART-MR10 Receiver
8 USERINFO User-application information
component
981073925
(0x3A7A0005)
DB_USERAPPAUTO Auto-starting user-application
firmware