User's Manual
Table Of Contents
- 6.5 Overlap
- 6.5 Overlap
- 6.5 Overlap
- 1. Introduction
- 2. Getting Up and Running
- 3. Hardware Overview
- 4. Launchpad Pro Interface
- 5. Session Mode
- 6. Note mode
- 7. Chord Mode
- 8. Custom Modes
- 9. Sequencer
- 10. Setup
- A. Appendix
- A.1 Default MIDI mappings
- A.1.1 Custom 1: 8x8 Grid, 8 Vertical Unipolar Faders, CC numbers below
- A.1.2 Custom 2: 8x8 Grid, 8 Horizontal Bipolar Faders, CC numbers below
- A.1.3 Custom 3: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.4 Custom 4: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.5 Custom 5: 8x8 grid, Program Change messages
- A.1.6 Custom 6: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.7 Custom 7: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.8 Custom 8: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.9 Programmer Mode: Includes buttons and pads (full 9x9 grid), logo LED may be addressed, Momentary Note On messages (note numbers below)
- A.1.1 Custom 1: 8x8 Grid, 8 Vertical Unipolar Faders, CC numbers below
- A.2 Overlap Layouts
- A.1 Default MIDI mappings
42
9.5.3 Pattern start and end points
The start and end point of Patterns may also be changed when in Pattern Settings. Pressing a step will
select the end step of the currently viewed pattern, with the end step displayed in peach. Hold shift
to instead view the start step of the current pattern (also displayed in peach). While shift is held, the
start step may be adjusted in the same way as the end step.
Steps that have notes assigned but fall outside of the selected start and end points are displayed in
dim red, while unassigned steps are not lit.
9.6 Velocity
9.6.1 Step Velocity edit
You can view and edit the velocity of each step by pressing Velocity.
The top two rows of the Play Area become a “slider” for the velocity value of the currently selected
step. To select a step, press a pad in the top half of the grid. The velocity value for the step will be
displayed on the velocity slider.
Press a pad on the slider to change the velocity of the notes on the step from 1 (minimum) to 16
(maximum).
When you manually edit the velocity of a step with multiple notes, all notes on the step will be set to
the same velocity value.
9.8.1.A – The Velocity view