User's Manual
Table Of Contents
- 6.5 Overlap
- 6.5 Overlap
- 6.5 Overlap
- 1. Introduction
- 2. Getting Up and Running
- 3. Hardware Overview
- 4. Launchpad Pro Interface
- 5. Session Mode
- 6. Note mode
- 7. Chord Mode
- 8. Custom Modes
- 9. Sequencer
- 10. Setup
- A. Appendix
- A.1 Default MIDI mappings
- A.1.1 Custom 1: 8x8 Grid, 8 Vertical Unipolar Faders, CC numbers below
- A.1.2 Custom 2: 8x8 Grid, 8 Horizontal Bipolar Faders, CC numbers below
- A.1.3 Custom 3: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.4 Custom 4: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.5 Custom 5: 8x8 grid, Program Change messages
- A.1.6 Custom 6: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.7 Custom 7: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.8 Custom 8: 8x8 grid, Momentary Note On messages (note numbers below)
- A.1.9 Programmer Mode: Includes buttons and pads (full 9x9 grid), logo LED may be addressed, Momentary Note On messages (note numbers below)
- A.1.1 Custom 1: 8x8 Grid, 8 Vertical Unipolar Faders, CC numbers below
- A.2 Overlap Layouts
- A.1 Default MIDI mappings
50
9.13 Sequencer Settings
In Sequencer settings you are able to change the current scale and root note, each Track’s type
(Drum, Scale, Chromatic), and the MIDI channel each track sends on.
9.13.1 Accessing Sequencer Settings
Sequencer settings may be accessed by holding shift and pressing Sequencer.
9.13.1.A - Sequencer Settings view
9.13.2 Track Types
The three track types available are Drum, Scale and Chromatic. Select between these three options
using the 3 pads at the top right of the grid. Choose which track you are altering by pressing the
Track Select buttons.
A preview of track type is given in the top left 4x2 section of the page. This represents the left-hand
side of the Play Area layout for each track type.
9.13.3 Root Select/Scale Viewer
The Root Select/Scale Viewer shows which notes are in the currently selected scale on a piano layout
keyboard. Blue pads show notes in the scale, the purple pad shows the root, and the dimly lit white
pads show notes outside of the scale. Press a pad in the Scale Viewer to change the root note of the
scale. The selected root note will persist throughout Note, Chord and Sequencer Mode.