User's Manual

32
• Displaying and Editing Pan Controls
After pressing the Options button, select the yellow ‘Pan’ button to access the pan controls for the eight tracks within
the selection ring.
• Displaying and Editing Send Controls
After pressing the Options button, the green soft key selects the Sends View. The screens will display a single send
control for each track shown on the screens. To bank through the available sends, click the up and down arrows to the
left of the screen. Raise or lower the send amount with the corresponding knob (above the send you wish to edit).
vi. Faders
Faders control track volumes in your Ableton Live set. These eight faders correspond to the eight tracks contained
within the selection ring.
• LED Indicators
The LEDs above the faders give visual feedback of the volume settings on the selected tracks. Since you can use the
faders on multiple tracks by moving the selection ring (see Live Set Navigation above), the actual position of the phys-
ical faders may not match the faders onscreen. The LEDs provide a solution by brightening and dimming if the volume
on an Ableton Live track is higher or lower, respectively.
vii. Undo, Redo, Metronome and Capture
While in InControl, holding Shift turns the rst three soft buttons above the pad area into Undo, Redo and Click con-
trols. As expected, Undo and Redo perform those functions on your Live Set’s most recent actions. Pressing Click
toggles Live’s metronome on or off.
Holding Shift will also display a Capture button if you recently played - but did not record - MIDI notes. Press this last
soft button under the screens to grab the MIDI you just played and place it in a clip, even though you were not record-
ing in the traditional sense.
D. Logic Pro X
i. Installation
To set the SL MkIII up with Logic Pro simply download the installer from the Support Downloads page - here.
Once downloaded the SL MKIII will be auto detected in Logic.
ii. Track Select
To select a track, press the button under the track name. It will highlight to indicate that you have chosen it.
iii. Pans
To control track pans press the Options button and choose ‘Pans’. From this view, the eight knobs will control the pans
for eight tracks at a time.
iv. Volume
To control track volumes, move the faders. The LED above the fader indicates the current track volume.
v. Sends
To control track sends, press the Options button followed by ‘Sends’. The eight knobs will then control Bus levels in
Logic. Press the up and down arrows to the left of the screens to change the selected send.
vi. Smart Controls
Logic uses smart controls to choose eight parameters for the selected plug-in on a chosen track. To control these,
press the Options button followed by ‘Smart’. From this view, the eight knobs will control the eight parameters as-
signed by Logic to be smart controls for the selected plug-in.