User's Manual

Preparation to use NTD37HD

To introduce preparation before you enjoy NTD37HD.

Procedure

1. Check whether all accessories are supplied properly.

2. Install HDD(Hard Disk Drive) into NTD37HD according to the procedure of HDD

installation(୔ note : HDD jumper should be set as Master)

3. Connect AC adapter into NTD37HD, and connect NTD37HD with PC through USB

cable

4. Power on NTD37HD(with power button of top side, or with power button of remote

controller)

5. In case that the installed HDD is not formatted, please format it first according to

normal HDD format procedure

6. Copy media files in your PC to the HDD of NTD37HD

7. After finishing copying files, disconnect NTD37HD from your PC system

8. Connect NTD37HD to TV set and(or) to audio system

9. Power on NTD37HD and change set-up value in SET-UP menu if needed. It is

recommended that NTD37HD should be rebooted if you set up Network newly

10. Now, you are ready to enjoy NTD37HD freely

HDD Size HDD Type HDD Capacity HDD RPM

HDD buffer

Memory

3.5” SATA HDD

SATA I or II

Any capacity

available in market

Over 7200 RPM Over 8M

Kinds of HDD to be installed