Installation Instructions

TOOLS NEEDED FOR ASSEMBLY
(not included)
Quesons, problems, missing parts? Before returning to your retailer, call
our customer service department at 844.404.4242, 8:00 a.m. - 5 p.m., MT,
Monday - Friday or email us at: support@novaoinc.com
GF-136
GF-365
GF-368
Applicable for the following faucet series:
Lock Nut and Screws
Metal Washer
Rubber Washer
Pipe
Hot
Flexible
Hose
Cold
Flexible
Hose
Steps to Complete Your Faucet Install
Hot Hose
O-Ring
Cold Hose
Pipe
Hot Hose
Lock Nut and Screws
Metal Washer
Rubber Washer
Cold Hose
Pipe
• Turn the handles on both the hot and cold water supply lines o so the water will
not be running through the pipes. These water supply lines will be located under
the sink in the cabinet.
• Screw the pipe on to the faucet and make sure the O-ring is on the faucet base.
Fasten the hot and cold exible hoses into the water supply holes on the boom of
the faucet if necessary.
• Carefully lower the faucet through the drilled hole.
• Slide the rubber washer and the 1.5-inch metal washer onto the pipe and ghten
the fastener.
• Aach the exible hose to the supply line source. The exible hose on the right
should be aached to the cold water supply line. The exible hose on the le
should aach to the hot water supply line. Tighten these connecons accordingly.
• With the faucet’s lever wide open, slowly turn the handles on the hot and cold
water supply lines to the open posion to your desired ow rate. Allow the faucet
to run for a couple minutes to get rid of any air pockets in the pipes.
BM-008
BM-012
BM-116
BM-359
TROUBLESHOOTING TIPS
Finish is changing color or is shiny
Abrasive cleaners, soaps or other
factors constantly in contact with it.
Soluon
Stop using abrasives; Replace parts
Issue Reason
New faucet needed; Tighten supply lines
Cracked casing inside; Supply lines
may be loose
Leaking from under the body
Remove ceramic cartridge, check for cracksCartridge may be defecveWater will not shut o completely
Tighten locking nut; Remove cartridge,
check for cracks
Lock nut has come loose; Ceramic
cartridge may be defecve
Leakage under the handle
TYPE ONE ASSEMBLY
Please Note:
• Review and abide by all building and plumbing codes
• Standard codes for Novao faucets: cUPC/CSA/AB1953
• Novao faucets need to be installed by a professional
• A 1.5” faucet hole is needed for installaon
• Max counter thickness 2”
Phillips