Full Product Manual

INSTALLATION
INSTRUCTIONS
Porcelain
Vessel
Sinks
Steps to Complete
Your Project
TP-V10W (sink only)
Please Note:
• Review and abide by all building and plumbing codes.
• Novao sinks need to be installed by a professional.
• Some counters require dierent cung methods; seek
the details of your chosen countertop material.
• Check to make sure the sink is sealed waterght.
Novao’s vessel sinks are to be installed
sing on the counter top. Most vanity heights are set
at 28”- 32”. Aer a vessel sink is mounted on top of the
counter the vessel height will be 34”- 36”.
• Layout and place the sink and faucet of your choice
in the desired locaon. Using a pencil, mark the drain
hole and faucet base. Consider the ow of the faucet
when marking the locaon.
• Drill the counter top for sink drain opening with a 1
5/8” drill bit. The faucet hole may be 1.5”
• Place the vessel on top of the counter and make sure
the drain ts down inside of the counter.
• Use a bead of clear silicone to seal between the out-
side edge of vessel where it is mounted to the counter.
• Use a level to ensure the vessel is level in every direc-
on and install
the drain.
• Secure the vessel to the counter with fastener on the
drain. Be sure to not over ghten the drain assembly.
Hand ghtening will be sucient.
When cleaning up aer installaon, do not use abrasive
cleaners. Use so soap and warm water with a washcloth
to clean the surface.