Installation Guide

TOOLS NEEDED FOR ASSEMBLY
(not included)
Phillips
Hot
Flexible
Hose
Cold
Flexible
Hose
TROUBLESHOOTING TIPS
Finish is changing color or is shiny
Abrasive cleaners, soaps or other
factors constantly in contact with it
Solution
Stop using abrasives; Replace parts
Issue Reason
New faucet needed; Tighten supply lines
Cracked casing inside; Supply
lines may be loose
Leaking from under the body
Remove ceramic cartridge, check for cracksCartridge may be defectiveWater will not shut o completely
Tighten locking nut; Remove cartridge,
check for cracks
Lock nut has come loose; Ceramic
cartridge may be defective
Leakage under the handle
Please Note:
• Review and abide by all building and plumbing codes
• Standard codes for Topia faucets: cUPC/CSA/AB1953
• Topia faucets need to be installed by a professional
• A 1.5” faucet hole is needed for installation
• Max counter thickness 2”
• Turn the handles on both the hot and cold water supply lines o so water
will not be running through the pipes. These pipes will be located under
the sink in the cabinet.
• Fasten the two bolts into the two threaded holes in the faucet. Make sure
the O-ring is on the base of the faucet. Fasten the hot and cold exible
hoses into the water supply holes on the bottom of the faucet if necessary.
Lower into the faucet hole.
• Holding the faucet in place at the desired position, slide the half moon
rubber washer and metal washer up the bolts. Take the two lock nuts and
tighten accordingly.
• Attach the exible hose to the supply line source. The exible
hose on the right should be attached to the cold water supply
line. The exible hose on the left should attach to the hot water
supply line. Tighten these connections accordingly.
• With the faucet’s lever wide open, slowly turn the handles on
the hot and cold water supply lines to the open position to your
desired ow rate. Allow the waterfall faucet to run for a couple
minutes to get rid of any air pockets in the pipes.
TYPE TWO ASSEMBLY
Steps to Complete Your Faucet Install
Hot Hose
Lock Nut
Metal Washer
Rubber Washer
Cold Hose
Long Bolt
Hot Hose
O-Ring
Cold Hose
Long Bolts
O-Ring
Metal
Washer
Long Bolts
and Lock Nuts
Rubber
Washer
Applicable for the following faucet series:
TF-85033