User Guide

112 Novell Native File Access Protocols Installation and Administration Guide
Novell Native File Access Protocols Installation and Administration Guide
103-000162-001
September 4, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Setting Up Novell Native File Access for UNIX with
Novell Cluster Services
To get the full benefit of using Novell Native File Access for UNIX with
Novell Cluster Services
TM
, the software must be installed and configured to
work in a cluster environment.
This section describes the following:
 Prerequisites (page 112)
 Configuring the Properties of Cluster Volume Resource (page 113)
 Component-Specific Configuration (page 116)
 Starting and Stopping Native File Access for UNIX with Cluster Services
(page 117)
Prerequisites
Before installing Native File Access for UNIX with cluster support, create a
shared volume and a Cluster Volume object.
1 Create a shared volume using NWCONFIG > NSS volumes.
NOTE: Do not use the name nfsclust because it is a reserved word.
2 To create a Cluster Volume object from ConsoleOne, complete the
following:
2a Select the Cluster object.
2b Click File > New > Cluster > Cluster Volume.
2c Browse and select the shared volume.
2d Enter the secondary IP address or the virtual IP address associated
with the cluster.
The address will be in the following format:
AAA.BBB.CCC.DDD
2e Check the Define Additional Properties check box and click Create.
2f Set the Start, Failover, and Failback Modes.
2g Verify the order of the servers in the nodes list.
2h To save the changes to the Cluster Volume object, click OK.