User Guide

Setting Up 91
Internetwork Packet Exchange
103-000176-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
If the diameter of your IPX network is close to the 16-hop limit, you should
run NLSP on the routers at the network boundary to ensure continued
connectivity across the network as it grows. Figure 13 provides a simple,
conceptual view of how this can work.
Figure 13 Running NLSP at the Boundary of a Large IPX Network
For more information about hop count, IPX routing, and related topics, refer
to Chapter 1, “Understanding,” on page 11.
How to Change the Hop Count Limit
To change the hop count limit, complete the following steps:
1 Load NIASCFG, then select the following parameter path:
Select Configure NIAS > Protocols and Routing > Protocols > IPX >
Expert Configuration Options
2 Select the Hop Count Limit parameter, enter a value between 8 and 127,
then press Enter .
3 Press Esc and save your changes.
4 Press Esc to return to the Internetworking Configuration menu.
5 If you want this change to take effect immediately, select Reinitialize
System .
If you want to configure other parameters, do so now, then reinitialize the
system when you are finished.
20 hops
5 hops
NLSP Routers
5 hops
NLSP RoutersRIP Routers
10 hops