User Guide

34 Filter Configuration
Filter Configuration
103-000178-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
When configuring this example, set the parameters as shown in Table 2.
Table 2 Parameters for IPX SAP Filter Example
How to Configure IPX RIP Filtering
Before you begin, make sure that filtering support is enabled for IPX in
NIASCFG.
To configure IPX incoming (or outgoing) RIP filtering, complete the
following steps:
1 Load FILTCFG, then select the following parameter path:
Select Configure IPX Filters > Incoming RIP Filters (or Outgoing RIP
Filters )
Parameter Value
Router 1 Action Permit Services
Router 1 Filters:
Filter 1:
Service Name
Service Type
Destination Type
Destination
Destination Circuit
Filter 2:
Service Name
Service Type
Destination Type
Destination
Destination Circuit
.
.
SRV-DEPT1
FFFF (All Types)
Interface
WAN-1
All Circuits
SRV-DEPT2
FFFF (All Types)
Interface
WAN-1
All Circuits
Router 2 Action Permit Services
Router 2 Filters:
Service Name
Service Type
Destination Type
Destination
Destination Circuit
.
CORP-MAIL
FFFF (All Types)
Interface
WAN-1
All Circuits