User Guide

60 Filter Configuration
Filter Configuration
103-000178-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
predefined services list. The allowable destinations are limited to the
corporate mail servers. Host 153.5.3.1 is the only mail server defined.
When configuring this example, set the parameters as shown in Table 6 .
Table 6 Parameters for IP Packet Forwarding Filter Example
Configuring AppleTalk Filters
AppleTalk supports the following types of filters:
Device hiding filters
Outgoing route filters (routes advertised)
Incoming route filters (routes accepted)
NOTE: When you configure a filter for a primary WAN call, an equivalent filter is
automatically generated for the backup call. If the primary call should fail, the
backup call is automatically connected. You can only view primary filters using
FILTCFG. Backup filters do not appear in FILTCFG.
Parameter Value
Action Permit Packets
Filters List
Filter 1:
Source Interface Type
Source Interface
Destination Interface Type
Destination Interface
Packet Type
Source Address Type
Destination Address Type
.
.
Interface
FDDI backbone
Interface
All Interfaces
Any
Any Address
Any Address
Filters List
Filter 2:
Source Interface Type
Source Interface
Destination Interface Type
Destination Interface
Packet Type
Source Address Type
Destination Address Type
Destination TCP/IP Address
.
.
Interface
NE2000_B
Interface
All Interfaces
SMTP
Any Address
Host
153.5.3.1