User Guide

Utilities 21
Utilities Reference
103-000153-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Driver Parameters
Depending on your system, one or more of the following parameters can be
used to identify a particular board.
Parameter Use to
DMA=number Specify the DMA channel for the board. Use
the same channel number you did when you
loaded the driver.
FRAME=number Specify the frame type for the board. Use the
same type you did when you loaded the driver.
INT=number Specify the interrupt number for the board. Use
the same interrupt number you did when you
loaded the driver.
MEM=number Specify the memory address for the board. Use
the same memory address you did when you
loaded the driver.
PORT=number Specify the I/O port for the board. Use the
same I/O port number you did when you
loaded the driver.
SLOT=number Specify the network board by the lot it was
installed in. Use this parameter with
microchannel and EISA computers. Specify
the same slot number you used when you
loaded the driver.
NODE=number Specify the node address for the board. This is
a 12-digit hexadecimal number.