User Guide

Utilities 127
Utilities Reference
103-000153-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
NSS DOS FAT Commands
Use these NSS DOS FAT commands at the server console:
 nss /(No)FATInMemory loads the entire FAT into memory for faster
access, regardless of its size. The default is OFF.
 nss /(No)FATLongNames enables long filenames on FAT volumes.
The default is ON.
 nss /(No)FATLazyWrites performs lazy writes of FAT. The
default is ON.
 nss /FATLazyWriteDelay=value sets the FAT lazy write delay (in
seconds). The default is 60. The range is 5 to 180.
 nss /FATPartition=partition_type_number supports up to three
additional partition types containing 16-bit FATs, such as /
FATPartition=12,13.
PURGE and SALVAGE Commands
Both PURGE and SALVAGE commands are supported and behave almost the
same in NSS as in previous versions of NetWare.
The SALVAGE command for the traditional NetWare file system and previous
releases of NetWare was either turned on or off for the whole file system. In
NSS, you can turn SALVAGE on or off for each NSS volume.
Use SALVAGE at the server console as follows:
 nss /salvage=all enables SALVAGE on all NSS volumes.
 nss /salvage=volume_name enables SALVAGE on the NSS volume
you specify.
 nss /nosalvage=all disables SALVAGE on all NSS volumes.
 nss /nosalvage=volume_name disables SALVAGE on the NSS
volume you specify.