User Guide

172 Utilities Reference
Utilities Reference
103-000153-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
RSP=value (Respond) Specify how the server should respond to a
broadcast request.
Replace value with one of the following:
NR: Specifies that all Broadcast Requests are to
be responded to directly; a Broadcast Response
isn’t required.
AR (the default): Specifies that all Broadcast
Requests are to be responded to with an All
Routes Broadcast frame.
CLEAR Clear the Source Routing table. Use when an IBM
bridge has gone down and an alternate route is
available.
CLEAR forces a dynamic rebuilding of the table by
sending a default frame to each specific node in
the network.
Use CLEAR to completely clear the Source
Routing table, or use REMOVE to clear only one
node address from the Source Routing table.
REMOVE=number Remove a specified node address from the
server’s Source Routing table.
Replace number with a 12-digit (6-byte)
hexadecimal number.
If you enter fewer than nine digits, ROUTE
prefixes the address with 4000 in hexadecimal.
For example, REMOVE=2 becomes
REMOVE=400000000002.
Use REMOVE when a bridge has gone down.
When you remove the node from the Source
Routing table, you force the server to determine
an alternate route.
XTX=number Specify the number of times to transmit on a
timed-out route, using the old route.
Replace number with a value between 00 and 255
seconds. The default is 02 times.
Parameter Use to