User Guide

174 Utilities Reference
Utilities Reference
103-000153-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Configuring Source Route End Station Parameters with INETCFG
You can use INETCFG to load ROUTE and configure many source route end
station parameters.
To use INETCFG, follow these steps.
1 Load INETCFG.
2 Select Internetwork Configuration > Boards to load a token-ring board.
3 Return to the Internetwork Configuration menu and use the Protocols
option to enable Source Route End Station.
4 Return to the Internetwork Configuration menu and select Bindings.
A list of bindings appears.
5 Select an existing binding or press Insert to add a new binding.
A list of enabled protocols appears.
6 Select Source Route End Station.
A list of boards is displayed.
7 Select the token ring board you configured with the Boards option.
The Attach Source Route End Station to an Interface menu appears.
The Source Route End Station parameters are listed in the following
table.
Table 3 Source Route End Station Parameters
Parameter Use to
Interface Name
(same as
NAME=board_name
command line parameter)
View the name of the interface to which the end station source router is
bound. This field is read-only.
Frame Type View or modify the source route end station list of frame types.
Press Enter to see the list. Press Insert to select a frame type. Press Delete
to remove a frame type.