User Guide

190 Utilities Reference
Utilities Reference
103-000153-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Compression Daily Check Starting
Hour = number
Specify the hour when you want the file compressor to start
scanning enabled volumes for files that need to be compressed.
Supported values: 0 to 23
Default: 0
Hours are specified by a 24-hour clock: 0 = midnight; 23 = 11 p.m.
Note: If the Compression Daily Check Stop Hour parameter is the
same as the Compression Daily Check Starting Hour, then the file
compressor starts checking every day at the Compression Daily
Starting Hour time and runs as long as necessary to finish all files
that meet the compressible criteria.
This parameter can be set in the STARTUP.NCF file.
Minimum Compression Percentage
Gain = number
Set the minimum percentage a file must compress to remain in a
compressed state.
Supported values: 0 to 50
Default: 20
This parameter can be set in the STARTUP.NCF file.
Enable File Compression = value Specify whether file compression is suspended.
Supported values: ON, OFF
Default: ON
ON allows file compression on compression-enabled volumes.
OFF suspends compression; immediate compress requests are
queued until value is reset to ON, when the files meeting criteria
will be compressed.
This parameter can be set in the STARTUP.NCF.
Maximum Concurrent Compressions
= number
Specify the maximum concurrent or simultaneous compressions
allowed.
Supported values: 1 to 8
Default: 2
Concurrent compressions can occur only if there are multiple
volumes.
This parameter can be set in the STARTUP.NCF file.
Parameter Use to