User Guide

Utilities 203
Utilities Reference
103-000153-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Error Handling Parameters
Error handling parameters control the size of error logs and specify what
happens when logs exceed the specified size. They also control how the server
responds to an abend or to an NLM
TM
that does not unload from a protected
address space.
For descriptions of error handling parameters, see the following table.
Table 8 Error Handling Parameters
Enable Disk Read After Write Verify =
value
Control whether information written to disk is read back and
compared with the original data.
Supported values: ON, OFF
Default: OFF
Setting this parameter to ON may decrease performance
significantly.
To set this value for currently loaded disks, use the Storage
Devices option of “MONITOR” on page 103.
You can set this parameter in the STARTUP.NCF file.
Parameter Use to
Server Log File State = number Control what happens when the SYS$LOG.ERR file is larger than
the size specified by the Server Log File Overflow Size
parameter.
Supported values:
0 = Leave SYS$LOG.ERR as is
1 = Delete SYS$LOG.ERR
2 = Rename SYS$LOG.ERR
Default: 1
You can set this parameter in the STARTUP.NCF file.
Server Log File Overflow Size =
number
Specify the maximum size of the SYS$LOG.ERR file before the
action specified by the Server Log File State parameter occurs.
Supported values: 65536 to 4294967295
Default: 4194304
You can set this parameter in the STARTUP.NCF file.
Parameter Use to