User Guide

208 Utilities Reference
Utilities Reference
103-000153-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Table 10 Memory Parameters
Parameter Use to
Average Page In Alert Threshold =
value
Specify the point at which the server sends an alert to the console
because excessive memory swapping indicates the server might
be low on memory.
Supported values: 0 to 4294967295
Default: 2000
The value of the parameter is the average number of pages
swapped from disk to memory per second, calculated over the
last five seconds.
If the average page-in rate is high, it means a large amount of
data is being swapped to and from disk, indicating that the server
might be running low on memory.
You can set this parameter in the STARTUP.NCF file.
Memory Protection No Restart
Interval = value
Prevent a server from restarting a protected address space that
continues to fault.
Supported Values: 0 to 60 minutes
Default: 1 minute
If the address space faults, but has already been restarted within
the time period specified by this parameter, the server will not
restart the address space. Restart functionality is disabled for the
address space.
A restartable address space that continues to fault consumes
server resources because the server is forced to continually shut
down and restart the space.
Setting the value to 0 disables the parameter so that the address
space will always be restarted if it faults.
You can set this parameter in the STARTUP.NCF file.