User Guide

Utilities 209
Utilities Reference
103-000153-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Memory Protection Fault Cleanup =
value
Enable the server to clean up a protected address space that has
faulted.
Supported Values: ON, OFF
Default: ON
If this parameter is ON and a protected address space faults, the
server removes the address space and its NLM
TM
programs and
returns the resources to the system.
If this parameter is OFF and a protected address space faults, the
server does not remove the address space or return resources to
the system. The situation is left to the abend recovery
mechanism.
You can set this parameter in the STARTUP.NCF file.
Garbage Collection Interval = number Specify the maximum time between garbage collections.
Supported values: 1 minute to 1 hour
Default: 5 minutes
You can set this parameter in the STARTUP.NCF file.
Alloc Memory Check Flag = value Specify whether the server will check for corruption in the alloc
memory nodes.
Supported values: ON, OFF
Default: OFF
You can set this parameter in the STARTUP.NCF file.
Reserved Buffers Below 16 Meg =
number
Specify the number of file cache buffers reserved for device
drivers that can’t access memory above 16 MB.
Supported values: 8 to 2000
Default: 300
You must set this parameter in the startup.ncf file. You cannot set
the value at the command line.
Parameter Use to