User Guide

158 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
If the problem persists, make sure a volume backup exists. Delete the volume,
re-create it, and restore the data from the backup.
FILESYS-X-769: Two volume segments with same sync value have mismatched data.
Source: FILESYS.NLM
Explanation: The values specified by two segments on the volume do not match. Another
message should follow this message to indicate which values do not match.
Action: Run VREPAIR and restart the system.
Warning: If you delete the volume, all data will be destroyed. You will have
to restore the data from a backup.
If the problem persists, make sure a volume backup exists. Delete the volume,
re-create it, and restore the data from the backup.
FILESYS-X-770: Volume has no volume name.
Source: FILESYS.NLM
Possible Cause: The MOUNT or DISMOUNT command was issued, but the volume name
was not specified.
Action: Specify a volume name.
FILESYS-X-771: Volume name name is too short.
Source: FILESYS.NLM
Explanation: A volume name must be at least two characters long.
Action: Make sure that you typed a valid volume name in the MOUNT console
command and that you spelled it correctly.
FILESYS-X-773: Invalid number of volume segments number.
Source: FILESYS.NLM
Possible Cause: During an attempt to mount a volume, the operating system determined that
the volume contained too many segments (there is an eight segment limit).
Action: Run VREPAIR and restart the system.
Warning: If you delete the volume, all data will be destroyed. You will have
to restore the data from a backup.
If the problem persists, make sure a volume backup exists. Delete the volume,
re-create it, and restore the data from the backup.