User Guide

FILESYS - File System Messages 163
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
FILESYS-X-787: Volume name first segment (number) does not start at block 0.
Source: FILESYS.NLM
Explanation: The first segment of a volume must start with block 0. While mounting the
specified volume, which is distributed over multiple physical disks, the
operating system could not find the first segment. The segment that it found is
not the first segment in the volume because it does not begin with block 0.
Possible Cause: The disk was corrupted.
Possible Cause: A hardware problem exists on the network.
Action: Before troubleshooting the problem, back up all data on the affected disk. See
Disk Errors in the Server Operating System Administration Guide.
FILESYS-X-788: Volume name last segment (number) ends at block number instead
of number.
Source: FILESYS.NLM
Explanation: This informational message indicates that the segment ends at a block that is
incorrect based on the operating system's calculation of where the segment
begins and how large it is.