User Guide

FILESYS - File System Messages 165
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Action: Run VREPAIR and restart the system.
Warning: If you delete the volume, all data will be destroyed. You will have
to restore the data from a backup.
If the problem persists, make sure a volume backup exists. Delete the volume,
re-create it, and restore the data from the backup.
FILESYS-X-817: Unable to initialize system auditing on volume name. Volume mount
aborted.
Source: FILESYS.NLM
Possible Cause: The operating system cannot open the audit file.
Possible Cause: The audit file is already at its maximum size.
Action: Check the size of the auditing file before continuing.
FILESYS-X-818: Unable to allocate memory to mount volume name.
Source: FILESYS.NLM
Possible Cause: The server is out of memory.
Action: Increase the memory available to the server. See Freeing Server Memory
Temporarily in the Server Operating System Administration Guide.
FILESYS-X-820: Overlapping segment entry found starting at offset number on server
for volume name segment number.
Source: FILESYS.NLM
Explanation: This informational message indicates that the operating system found an
overlapping disk area when it tried to mount the volume. The operating system
will discard the volume.
FILESYS-X-823: Drive failed while reading in volume information tables.
Source: FILESYS.NLM
Possible Cause: The drive holding the volume had a physical failure while the volume
information tables were being read.
Action: See Disk Errors in the Server Operating System Administration Guide.