User Guide

FLAG Messages 169
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
FLAG-x-400: This utility was unable to set the DOS file.
Source: FLAG.EXE
Possible Cause: The file might be corrupted.
Action: Try to read or run the file. If you can, flag the file again. If you can't, the file
is probably corrupted. Get a new copy of the file, then flag the file.
FLAG-x-425: The specified attribute(s) is not supported in this version of NetWare.
Source: FLAG.EXE
Possible Cause: The user specified an attribute that is not supported by the NetWare
®
server
where the file is located.
Action: Get a list of attributes supported by the server where the file is located by
typing FLAG /? at the command line. Make sure to run FLAG from the drive
mapped to the file's location.
FLAG-x-441: The /DO command is not supported for local drives.
Source: FLAG.EXE
Action: When referencing local drives, do not use the /DO command line option.
FLAG-x-450: Owners cannot be assigned to local drives or files.
Source: FLAG.EXE
Possible Cause: This attribute is not supported with files on local drives.
Action: When assigning attributes to files on local drives, do not use this attribute.
FLAG-x-450: The attribute_name attribute is not supported for local files.
Source: FLAG.EXE
Action: When assigning attributes to files on local drives, do not use the specified
attribute.
FLAG-x-450: The Search mode is not supported for local files.
Source: FLAG.EXE
Action: When searching local drives, do not use the search mode in FLAG.