User Guide

212 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
LANSUP-DOS-X-003: Could not find LANSUP MLID to unload.
Source: LANSUP.COM
Explanation: The user or another program was trying to unload the LANSUP driver and was
not loaded.
LANSUP-DOS-X-004: A TSR is loaded above the LANSUP MLID.
Source: LANSUP.COM
Explanation: Another TSR (terminate-and-stay-resident) program was loaded after the
LANSUP driver.
Action: The drivers must be unloaded in reverse order, as follows:
C:\NWCLIENT\NETX /u <Enter>
C:\NWCLIENT\IPXODI /u <Enter>
C:\NWCLIENT\LANSUP /u <Enter>
Unload the TSRs; then try to unload the LANSUP driver. You can force the
LANSUP driver to unload from the command line by using the /F switch after
the driver name, as follows:
C:\NWCLIENT\LANSUP /f <Enter>
Use caution when using the /F switch because it could cause the system to
hang.
LANSUP-DOS-X-005: LANSUP MLID could not be unloaded; the operation was
aborted.
Source: LANSUP.COM
Possible Cause: The LANSUP driver could not be shut down and unregistered; consequently,
it cannot be unloaded.
Action: To unload the driver, reboot the system.
LANSUP-DOS-X-006: The adapter did not initialize. LANSUP did not load.
Source: LANSUP.COM
Possible Cause: The LANSUP driver encountered an error while loading.
Action: Corrective action can vary. See the preceding driver-specific message on the
screen for specific information about the error that occurred.