User Guide

214 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
LANSUP-DOS-X-012: The protocol keyword must have a frame type. Entry ignored.
Source: LANSUP.COM
Possible Cause: The PROTOCOL keyword entry is incomplete.
Action: Correct the protocol entry in the NET.CFG file. The proper syntax for the
protocol keyword is as follows:
PROTOCOL LANSUP hex_protocol_ID frame_type
LANSUP-DOS-X-013: The MLID could not register Protocol ID number for protocol
stack name for frame type frame.
Source: LANSUP.COM
Possible Cause: The Link Support Layer (LSL) is configured with resources for a set number
of Protocol Identifiers. (The default is 4.) This number has been exceeded.
Action: Edit the NET.CFG file, and add the MAX STACKS keyword to reflect the
number of network boards to be loaded, as in the following example:
LINK SUPPORT
MAX STACKS 6
Unload the driver; then reload it as in the following example:
C:\NWCLIENT\LANSUP /u <Enter>
C:\NWCLIENT\LSL /u <Enter>
C:\NWCLIENT\LSL <Enter>
C:\NWCLIENT\LANSUP <Enter>
LANSUP-DOS-X-014: This version of the LSL is not supported.
Source: LANSUP.COM
Explanation: The driver the computer is using supports only Link Support Layer (LSL)
versions later than 1.0.
Action: Unload the LSL and replace it with a newer version.
LANSUP-DOS-X-015: The frame type is already active for frame type.
Source: LANSUP.COM
Possible Cause: The frame type is already loaded, and it cannot be loaded repeatedly.
Action: Edit the NET.CFG file to load the frame type only once for a given network
board.