User Guide

LANSUP-DOS Messages 215
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
LANSUP-DOS-X-016: The node address was incorrectly specified in the NET.CFG file.
Source: LANSUP.COM
Possible Cause: The node address override in the NET.CFG file is too long.
Action: Edit the NET.CFG file and correct the node address. The node address must
be less than or equal to 12 hex digits.
LANSUP-DOS-X-017: An invalid keyword was specified in NET.CFG on line number.
Source: LANSUP.COM
Possible Cause: The key word on the line indicated was not recognized.
Action: Edit the NET.CFG file and correct the spelling of the keyword.
LANSUP-DOS-X-018: The frame type specified in the NET.CFG is not supported.
Source: LANSUP.COM
Possible Cause: The frame type specified with the FRAME keyword is not supported by the
driver.
Action: Edit the NET.CFG file and fix frame type.
LANSUP-DOS-X-019: An invalid LANSUP node address is specified in NET.CFG. The
MLID modified the incorrect address bits.
Source: LANSUP.COM
Possible Cause: The node address specified in the NET.CFG file has set reserved bits.
Action: Edit the NET.CFG file and correct the node address.
LANSUP-DOS-X-050: [ISA bus | Microchannel] The board cannot be found.
Source: LANSUP.COM
Explanation: If the computer is using an ISA bus network board, the network board was not
found due to one or more of the following conditions:
Possible Cause: The network board is not present in the computer.
Action: Make sure the network board is properly seated into the slot.
Possible Cause: Another network board is using the same hardware settings as this network
board.
Action: If other network boards are using the same hardware settings, change the
settings and try to reload the driver.