User Guide

LOGIN Messages 235
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Possible Cause: The network supervisor can disable the login function temporarily to prevent
users from logging in or attaching during system maintenance. Most likely, the
network supervisor is doing maintenance work and has disabled the server.
Action: This condition is usually temporary. Try to log in after the login function has
been enabled. If using CAPTURE or NPRINT, attach to another server and use
its printer. Make sure that the SYS: volume is mounted on the server. If the
problem persists, contact a Novell support provider.
LOGIN-X-430: The following drive mapping operation could not be completed.
Mapping. The error code was code.
Source: LOGIN.EXE
Explanation: The uesr tried to map a drive to a path that does not exist or cannot be found
by LOGIN.
Action: Make sure to map a drive to a valid path. For information about a specific error
code, search the Error Codes online documentation (http://www.novell.com/
documentation/lg/nwec/docui/index.htm).
LOGIN-X-440: The operation was attempted on an invalid drive.
Source: LOGIN.EXE
Possible Cause: The user tried to manipulate an invalid drive using MAP. For example, if L:
had not been previously mapped, entering MAP DEL L: would produce this
error.
Action: Make sure that the command is entered correctly in the login script.Make sure
that the drive is mapped correctly.
LOGIN-X-450: This utility was unable to map drive. The limit of 16 search drives was
exceeded.
Source: LOGIN.EXE
Explanation: The workstation is limited to 16 search drives.
Action: Delete an unwanted search drive to make room for the drive to be added. To
delete the drive, use the MAP DEL search_drive or MAP REM search_drive
command.